Bummer. It's gorgeous, and I want to like it, but the restricted airhole seems to be causing problems with vapor production. I'm using a microcoil on a mech mod at about 1.2 ohms, with cotton. Do you think I would do better with another build? Thanks!
Ok, so I meshed it up, with a microcoil, at about .9 ohm. Still eh for vapor, so I drilled it out (eek) but very tidily (yes, I even drilled the interior air post), and it's quite a bit better. I like the fact that it's hard to make this guy leak - and like I said, it sure is an attractive piece.
My former comment didn't stick, but I find the draw on this to be nearly unacceptably tight. Thoughts on making the exterior air hole bigger?
ReplyDeleteSorry to say that I do not have this atty anymore so can't really help on this one Adam.
ReplyDeleteBummer. It's gorgeous, and I want to like it, but the restricted airhole seems to be causing problems with vapor production. I'm using a microcoil on a mech mod at about 1.2 ohms, with cotton. Do you think I would do better with another build?
ReplyDeleteThanks!
Try it, get some mesh in there and give it some beans :D
ReplyDeleteOk, so I meshed it up, with a microcoil, at about .9 ohm. Still eh for vapor, so I drilled it out (eek) but very tidily (yes, I even drilled the interior air post), and it's quite a bit better. I like the fact that it's hard to make this guy leak - and like I said, it sure is an attractive piece.
ReplyDelete