Tutorial - Brushing Stainless Steel

Hopefully this helps someone out, been asked to show this a few times now :)


Comments

  1. Hi Todd, Just been watching the video and thought of an idea. If you could get the tank/mod attached to a threaded rod with some sort of expanding material in the centre, like a piece of rubber a couple of big washers and a couple of nuts you could mount it on a drill and just hold the wet and dry around it. Would save a lot of arm work :)

    Take care Buddy

    ReplyDelete
    Replies
    1. Pretty much what I already do mate, I use the spindle on my bench grinder but not every one has a drill (why!) so showing it the manual way.

      All the best

      Todd

      Delete
  2. Hello Todd. Great tutorial and looks great.

    ReplyDelete
  3. Wow that really looks great with the contrasting finishes. I was wondering if you were careful not to take too much material off if this would work with a chrome finish? Maybe giving it a bit of a frosted appearance like the stainless steel. Thanks for posting this, I have an ody clone that has some blemishes that I'm going to try it on and then maybe a mod if you think it might work on the chrome.

    ReplyDelete
  4. hey todd been away for awhile like the additions to the site, ss mesh sizes and what not, very nice polish job on your mod i think it looks better now than when it was new , been busy up here on the mountain gardening since spring has arrived and also restoring the redwood deck ( replacing rotted floor joist and resurfacing the deck boards ) got several vids to catch up on keep up the good work.....willie

    ReplyDelete
    Replies
    1. Hi Willie,

      Good to hear from you stranger :)

      I'm actually just heading out the door this sec to go buy new wood for my decking as well LOL

      All the best

      Todd

      Delete

Post a Comment